Quote:
Originally Posted by Pailai
I just recently bought this LCD from best buy and I have a cut out/cut in (the LCD seems to cycle for a brief moment) when just sitting there. It does it more when it's "warmed up" but it's not overheating (from what i can tell), and it does it more when i put the 1920x1080 res to it. I'm using a x1600 ati card with monster DVI to DVI cable. Also using catalyst drivers and catalyst control center ver. 1.2.2425.37188. it's doing it right now...i'm in "clone mode" with my real lcd as the main, but even if i disable my main and only use the westy then it will do that cut out/cut in thing every now and again. Please advise i don't know what to do. ps the firmware on the tv is 1.19 and should be current.
-Ken
|
The X1600 is capable of HD resolutions. You are using Catalyst 6.9? Also, make sure the Video Card is properly identified in Device Manager. It should not say something like "X1600 series", it should list the exact model of the video card. I have seen this be an issue. Rule out a bad driver installation by performing a clean installation? Remove driver via add/remove programs in the control panel, reboot and then reinstall driver.
I noticed you mentioned "warm-up". Do you mean the issue does not occur until after the unit has been on for a few minutes? If so, it sounds like bad hardware.
Later..
Remember to verify the basics. Check the cable, also try again cable? Also talk to Westinghouse about it.. Sometimes issue exist that are not known to the public..